Remote controller for OSD menu. Compatible with cameras with UTC technology.
This simple wired control has a female BNC input and a male BNC output. Powered by a CR2025 battery. It has buttons with the typical functions: Cursor up / down / right / left, OK, Menu entry and Menu exit.
The use is very simple, it should simply be located anywhere between the camera whose OSD menu you want to access, and the monitor (that is, it can be located just outside the camera or at the cable outlet Connects the camera to the recorder or monitor). From now on, and whenever the camera has UTC technology, you can enter and configure your menu without having to press the camera buttons directly. This greatly facilitates the installer's job, which can configure each display parameter without having to physically access the camera, and with the monitor in front. In addition, a single command can be used in any desired installation by simply plugging it into the new installation.